PCIM

PCIM > House Plan Drafting 101 & Mechanical Drafting 101 > Drafting Board Lessons > Dimensions on drawing
Full Version: Dimensions on drawing
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Yeh Yeh

02-13-2008, 05:55 PM
I'm adding the dimensions to my drawing and would like to compare to your drawing, however I cannot make out the numbers on your drawing. Is there anyway you could make it where you could click on the drawing and expand like you did for the sketch?
Thanks,
Yeh Yeh

The Parson

02-14-2008, 04:20 PM

Yeh Yeh Wrote:
I'm adding the dimensions to my drawing and would like to compare to your drawing, however I cannot make out the numbers on your drawing. Is there anyway you could make it where you could click on the drawing and expand like you did for the sketch?
Thanks,
Yeh Yeh

Here ya go Yeh Yeh. A PDF of the full lesson drawing.

Tim

PCIM > House Plan Drafting 101 & Mechanical Drafting 101 > Drafting Board Lessons > Dimensions on drawing
Reference URL's